Can someone with a bullet master tell me if the arms that hold the mould halves are only spring loaded? My MC has a spring to bring the halves together but have two guides to hold them in place when the sprue is cut off and under the pour spout. Does the bullet master have this setup too? as i have noticed that with changing moulds on my MC, on some moulds i need to adjust the guides. With 8 moulds on a bullet master, how do you ensure each mould is touching the guide (if it has said guides)?
I'm half considering trying to build my own version of a bullet master, it may work, it may fail miserably. I have seen a few videos on you tube of what i think was an Italian remake of a bullet master, 8 moulds driven by an electric motor with a reduction drive, no ratchet action. I assume PLC control to index the moulds under the pour spout.
It's all just in my head at the moment, see if i actually get it made and more importantly, if i can get it to work!