Guys quick question I slug my bore at 0.3567
I wonder should I run plated at .0357
And lead at .0358 ?
Cal. 9 mm
|
   
   
|
|
Guys quick question I slug my bore at 0.3567
I wonder should I run plated at .0357
And lead at .0358 ?
Cal. 9 mm
Last edited by lonewolf5347; 05-12-2017 at 11:08 AM.
I'd try both at .358"...( did you mean .357" and .358"?)
Last edited by mdi; 05-13-2017 at 11:20 AM.
My Anchor is holding fast!
I treat plated like lead, go bigger if it fits.
EVERY GOOD SHOOTER NEEDS TO BE A HANDLOADER.
NRA Cert. Inst. Met. Reloading & Basic Pistol
As long as the boolit is as big as the groove dimension, round and will obturate WHEN IT LEAVES THE CASE it will work. A thousandths or 2 over size compensates for defects.
Did you size with pure? Lot of guys state they are sizing with boolits - tin and antimony causes springback. When measuring to four digits this causes error, reading too large a size.
Wayne the Shrink
There is no 'right' that requires me to work for you or you to work for me!
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote