Thanks for the suggestion and offer, boolits and dies should be here tomorrow, hope to get out later in the week/over the weekend, will post results.
Thanks for the suggestion and offer, boolits and dies should be here tomorrow, hope to get out later in the week/over the weekend, will post results.
Some would (have) question(ed) your measurements. Just to make any of those questions go away, could you post measurements of your 44 brass OD before and after firing. I did have a caliper "slip a notch" once and ruined a bunch of parts I was making.
Cast is where I live and have bettered groups shot with jacketed many times. Many of my guns have never seen a "J" word. I am of course a revolver nut and have shot one hole groups at 50 yards, 1/2" at 100 and 2-1/2" at 500.
I question measurements since I have an old set of calipers that I can read to .0005" although it is not made for that and my friend can't read it at all. But I depend on a good mike first. He is confused with it too. Have to watch some of the calipers with a dial readout. To think they are making some out of plastic.
I just have to think your gun is OK.
Work, weather etc is doing it's thing, will post with results when I can.
head over to the swap area for bullet trading, you'll likely get a few offers of samples you can try.
since you're new to the cast bullet thing, I'd try with a standard keith 240gr or the 429667 to start with. both will do well for hunting deer and both should shoot reasonably well with average loads to try at starting.
http://noebulletmolds.com/NV/product...oducts_id=3600
I went this route with a wide flat nose I am plaining on using it in my Handy rifle in 444 Marlin I am looking at pushing it a lot harder than what you are I believe this one is up to any thing that walks in the lower 48 states. I don't think slowing the boolit down that slow would get very good results I would think going lower than 1300 FPS would perform worth doing.
So much great information in the replies here.
Haven't had a chance to work on this lately and in reading through peoples answers I'm realizing I asked a lot of connected, but separate questions at once.
Going to back up a little, attack a few on their own and then come back to mould selection.
Awesome site and thanks again for such helpful advice!
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |