Just got my new mold from NOE this weekend. It is the HTC452-230 boolit mold designed for hi-tek of powder coating. No lube grooves on these bad boys. After heat cycling and preheating, the keepers rained from this mold. Very happy with it and just wanted to share it with ya'll because I haven't seen a lot of talk about them. I resized them to .452 and they loaded and shot beautifully out of my 1911, one pass through with a bore snake and the barrel was clean. Check these molds out if you coat exclusively. Now if I can just get a mold like this in a H&G68 pattern. Pictures below.