Afternoon all
Looking for some advice/ guidance before I drop the hammer on a mold purchase.
Handgun is a Smith 625
Currently using plated 200 gr t.c. that I had loaded up for my 1911, and I've had pretty good luck with that design so far. Might clock the powder charge back a bit, but seem to work well for what I'm doing.
I'm leaning towards Accurate mold's design 45-200I http://www.accuratemolds.com/bullet_...=45-200I-D.png , mostly for the groove-less design, as I plan on powdercoating them.
As this seems to be the "go-to" center of the internet casting universe, has anyone else used this design? Had success with it? Had bad experience with it?
Intended purpose is low velocity, steel plates shooting
Any info, is appreciated
Dan