So, I have this Star sizer and only one die for it, in. 3565 of course, not .451 for my Saeco 68's.
But, I do have a .451 for my saeco sitting here.... so I went out to the shop and scrounged around for ..... a spring to wrap my saeco die with that would center it in the star luber, and it works. Well,, 99% so far, I need to block off the extra rows in the saeco die so I can actually get the lube in the boolit grooves instead of on the base or the nose. I tried blocking them with shot but the hydraulic pressure just forced the shot right thru but my next attempt will be with "beagling tape", it should withstand the pressure better and I may not even need a spring to center the die,, just a wrap or two of tape.
If this all works I will be adapting both my saeco and my lyman dies to fit the star since I am rather forced to make do with what I already have. The spring I used was plastic coated so it worked well to seal the lube, but the beagling tape may just do it all.