What press does this priming arm fit? It is almost 4" long and about 0.368" thick.
[ATTACH=CONFIG]183375
What press does this priming arm fit? It is almost 4" long and about 0.368" thick.
[ATTACH=CONFIG]183375
Sorry, never saw one like it.
Its similar to the one on my old Rock Chucker. RCBS.
jim
It appears identical (even the width) to the one on my Dad's old Herters press. I doubt if Herters actually made most of their stuff so maybe it will also fit some thing else.
merry Christmas,
Dennis
Kootne is correct; I just dug my HERTERS priming arm out and also verified the measurements . There should be a drilled out spot for a coil spring about 3/4 inches from the mounting hole . The unit came with a spring loaded priming arm as shown for large primers and also a spare plunger/seater for small primers. I took the assembly off my old press years ago and use a hand primer instead.
That one looks almost like the RCBS and Lyman Uni. primer assembly.They are both the same lenght and the hole to put the pin in for the press.Also have the seater for the primers for larger and small,same with a spring.I use that on my Lyman T press.
Life Member of NRA,NTA,DAV ,ITA. Also member of FTA,CBA
Herters, YUP
NRA Benefactor 2004 USAF RET 1971-95
looks like the one on my ECHO
I Am Descended From Men Who Would Not Be Ruled
Fiat Justitia, Ruat Caelum
There is enough fat in the federal government that if you rendered it you could wash the world
Ronald Reagan.
Doesn't fit my brother's Lyman Spar-T.
Doesn't fit any of my presses.
Hmmm?
Love it when a plan comes together.
Brass magnet, I hope he also gave you a bunch of HERTERS shell holders to accommodate your ammo. My old HERTERS press does not take current RCBS-type shell holders. GOOD NEWS: I have an adapter to use commercially available shell holders on my old HERTERS press. BAD NEWS: As it is longer than the HERTERS original with a commercial shell holder on it, the priming arm is now too short to seat a primer fully ...... which was the original reason that I went to off-press priming (but later found that it works better for me anyway)
I Am Descended From Men Who Would Not Be Ruled
Fiat Justitia, Ruat Caelum
There is enough fat in the federal government that if you rendered it you could wash the world
Ronald Reagan.
I Am Descended From Men Who Would Not Be Ruled
Fiat Justitia, Ruat Caelum
There is enough fat in the federal government that if you rendered it you could wash the world
Ronald Reagan.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |