I really need one of the .30 cal. tools
I really need one of the .30 cal. tools
I'm not sure our Checkmaker will work with copper that thick. It will work with .010 and thinner material.
The reason we are sticking with .010 is the cost of thicker copper increases 3 fold and over.
A Democrat that owns Guns is like a Vegan that owns Cats...
C2N14... because life is not energetic enough.
Gott und Gewehr mit uns!...
Death is only The End if you assume the Story is about You.
1.618034 Fnord
מנא, מנא, תקל, ופרסין - Daniel 5:25-28 - Got 7.62?
Patmarlin,
not to worry,0.010" is 0.25mm.
And I'm sure our dies will work with even thicker copper.
My homemade punchdie cuts easily 0.510" diameter disks from 0.020"=0.50mm annealed coppersheet at the end of presses stroke (Rockchucker).
Good luck,those .22 checkmakers are really gonna be a challenge,hope you can make them too,with reasonable price.
Kaj
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |