This is a new master caster. I feel like the molds aren't aligned perfectly. the bullet is slightly out of round ranging between .4525 and .4555. It seems like if I run my finger nail over the line there is a high side and a low side. I can feel my finger nail catch going one way and it drops down and is easy to go across the other way. The line also appears to only be on one side of the bullet. The other side where the halves mate I can see the line visually but I can not feel it.
If if the molds aren't aligned properly how do I go about fixing that?
I also noticed that when the mold opens up the mold halve on the right lifts up slightly compared to the left halve. I suspect this is normal operation of the Machine from the Sprue plate contacting the rod to open it. But what do I know? I figured I would add it in just in case