Recently purchased the NOE sizing body die and B433 (body) bushing. Cast some bullets from my 432-290 GC mold and they come out .432. Powder coated them and they come out at .434-.435, then tried resizing and adding a GC and got multiple stuck inside the sizing die. Then I tried to size a bullet before I powder coated and they came out looking like this.
this has me puzzled. Not only should they not size at all but they look like they have been run over sandpaper. I can feel tool marks all the way through the bushing; I've never felt that through my Lee push through dies. My question is am I doing something wrong, did I get a lemon?