Not that 458WM brass is hard to come by or overly expensive but has anyone on this board done this or currently doing this?
I am new to blowing out brass but read and researched a lot before dipping my toes into this new pool. So far I have formed 10 brass cases successfully doing the following: 1) Size and deprime using a Hornady 458WM FL die. 2) Cleaned using SS pins wet tumble with Dawn and LemiShine. 3) Annealed case neck. 4) Primed using LPP and loaded with 12gn RedDot, wad of TP, cornmeal to case neck and plugged with paraffin wax. 5) Fired in Ruger M77. 5) Trimmed to 2.50" & deburred and chamfered. 6) Sized & deprimed. 7) Annealed. 8) Cleaned with SS wet tumble.
What say the folks with experience, what am I missing or doing wrong?