Hey guys - I'm finishing up my birthday order tonight which consists of another set of dies and some tumbling equipment, but I'll soon be out of purchased bullets so I'm looking for recommendations for a good .45 ACP mold.
I'm mostly looking for a good target bullet, so something around a 200 gr SWC would be good, but I'm not sure which one to get. I had always wanted to follow in Dad's footsteps, but he had almost all Lyman molds, which are a bit more costly. I've looked at Lee Molds and they have a couple of 200 grain molds - the 200 grain SWC and the 200 grain FN. I like the looks of the FN, and while two of the reviews say it works great for their 1911s, another says that this particular bullet likes to jam because the meplat is too wide. Does anyone have any experience with this?
While the ultimate goal is to go for Lyman molds, I think I want to start with some Lee equipment first, mainly because I can get into an ENTIRE Lee casting setup for about the cost of the mold and handles if I go with Lyman.
So, all thoughts and experiences regarding the matter are most welcome!