I recently bought a freecheck 3, an arbor press from harbor freight, and 1/2x.0145 aluminum roll from coil and foil. my problem is that my checks keep smearing. I am using a lee push through .311 sizing die. the bullet is a lee 155gr cast out of clip on WW. they are about 1 week old. I use to use hornady with no problems, and I have tried Vulcan checks with no issues. what am I doing wrong? I keep getting a little notch in each gas check, and that is also where it seems to smear 90% of the time. some of my Vulcan checks had the same little notch, but seated just fine. HELP! thanks in advance.