.401 200 gr WFN bullet mold

[molar]

I'm looking for a .401 200gr wide flat nose bullet mold similar to what beartooth bullets and double tap uses. Can't find one anywhere. Is this a custom mold proposition?

[spfd1903]

I bought an NOE 403-200-WFN last fall for 10 mm. They have four and two cavity Aluminum and brass molds. Does great in my Glock 20.

[molar]

I bought an NOE 403-200-WFN last fall for 10 mm. They have four and two cavity Aluminum and brass molds. Does great in my Glock 20.

Thanks. Do you use the stock Glock barrel or do you have an aftermarket barrel? If aftermarket, do you have feed issues? I have a threaded KKM barrel with a short throat. Afraid it might give me issues. I guess I could powder coat them and run them through the factory barrel.

[pmer]

I have the NOE 403-200 as well. I have been shooting them uncoated in a factory Glock barrel, they size to around .402 and have been working good with upper level charge of AA #9. It's a 10mm G40 and been a bugger to group well but it likes this boolit. It throws brass pretty far compared to factory 10mm.

[spfd1903]

I have been shooting them from a Lone wolf barrel with no feed issues,sized to .401 and .402. I am finding AA#9 does yield the smallest groups. Agree with the brass ejection distance...impressive. I now have the most accurate load weight for AA#9, and will try them out of the stock barrel next time around.

[molar]

I have a set of Lyman mold handles and Lee handle for the 6 bullet commercial mold. Will either of these handles work with the NOE mold?

[spfd1903]

The Lee six cavity mold handles will fit the NOE molds with no issues.

[harley45]

You might also check with MI-HEC and see if he has a copy of OREOs design it is an amazing mold. I'm sure the NOE is awesome to as I have a couple of his just not that one yet.

[shooter93]

Accurate molds also.