So what is the reason for the difference in neck dimensions? A 30-30 has a .003" taper, a 30-40 Krag has about .001", a 30-06 is straight. Why? Is one better?
Thanks.
So what is the reason for the difference in neck dimensions? A 30-30 has a .003" taper, a 30-40 Krag has about .001", a 30-06 is straight. Why? Is one better?
Thanks.
SOme of this is due to the extraction exerted by the action they were chambered in. The camming of bolt actions did much better than single shots or lever guns at Pulling the fired cartridge out.
Are you looking at a cartridge drawing or a chamber drawing?
First reload: .22 Hornet. 1956.
More at: http://reloadingtips.com/
"Any man who thinks he can be happy and prosperous by letting the
government take care of him better take a closer look at the American Indian."
- Henry Ford
Looks like both for 30-30 and 30-40. 30-06 cartridge is straight but the chamber is tapered according to SAAMI.
30-40 Krag.pdf
30-30 Winchester.pdf
30-06 Springfield.pdf
Sammi spec for the 30-06 chamber shows a .0021 taper.
dies are cut straight the chambers are cut tapered.
the chambers are tapered to draft angles so you can get the brass in and back out of them easier.
if I had the choice I wouldn't have a rifles neck cut with a taper.
I tried to get the XCB rifles reamer cut without the neck taper.
The chamber necks are specified to be tapered because there is some tolerance required when manufacturing anything.
The taper of the neck is equal to the tolerance permitted for the neck diameter. This is just ordinary engineering practice.
If the case mouth goes to maximum size and the base of the neck goes to minimum size you will have a straight chamber neck.
Without this convention you could wind up with the chamber mouth larger than the base of the neck and a fired cartridge will lock itself into the chamber when it expands.
Reloading dies do not have that taper most of the time.
However you can find old BPCR dies that faithfully reproduce the neck taper of some of the old rounds. However when you expand the case and seat a bullet you effectively make the neck straight.
What we choose can often be different from mass production manufacturing.
Sure we can use a straight neck but it might not be such a good idea for a half million rifles that will be used in combat.
EDG
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |