Swage-it?

[ncbearman]

Any feedback from this company?

http://hawkbullets.com/swage-it.htm

[uncle dino]

NC. I bought a couple of dies quite a few years ago..worked pretty well for a simple swc design. D

[GerryM]

NC. I bought a couple of dies quite a few years ago..worked pretty well for a simple swc design. D

I have the 45 die , It works pretty well.
The problems are 1 you need some kind of core seater die and 2 a bleed die sure would help.
They do give you a deal on the mold if you buy the die.
I ordered the round nose style It not exactly a good transition to round nose but with the right adjustments they work pretty well as I said before.

I'm spoiled on dies I like to make all of my bullets weigh the same .

[Sasquatch-1]

I have one of their dies in .44 cal. Mine has a round nose, semi wadcutter and wadcutter nose punch. I did crack the SWC nose punch and the original die had a bulge in it. I called and the parts were replaced with the only stipulation, that they wanted the parts back to examine them. I have since obtained sets of Richard Corbins dies and use the Swage-it dies for reshaping cast bullets.

These will only make step bullets and any jacket cannot go past the step.

The prices in the ad you have posted are not correct. The dies run about $180.00. he sells them on Ebay.


This is the only die I saw that he had on line right now. check the contact info and call him he may have others available.
http://www.ebay.com/itm/380-acp-Cal-...QAAOSwu4BVjKb4