Hi Guys, I need some help. I'm new @ casting & would like some info for mild loads for my 357 & 44 mag. I already load & cast for 45acp, 38 spec & 9mm. I use Unique for just about everything so it would be great if I were able to use it with the other loads. There isn't much info out there for this powder & cast bullets. I use a Lee TL 356-124-2R for the 9mm & 38spec, it works fine. I would use the same bullet for the 357. Don't have the mold yet but would probably go with the Lee TL 240 semi wadcutter for the 44 mag. I've had real good luck with these, no sizing required, just tumble lube & load. If you have any sugestions I would appreciate them, the guns I will use are a 4" S&W model 19 & a 6 1/2" S&W model 29. Would a gas check be needed for mild 44s? Thanks for any info. NRA PATRON LIFE MENBER