Finally got to my neck turning tool project. Turned out ok and works great.
Uses standard 1/2" square carbide cutting tips. Used a pin gauge for guide pin.
Not the prettiest but not bad limited to a drill press and hand tools.
Finally got to my neck turning tool project. Turned out ok and works great.
Uses standard 1/2" square carbide cutting tips. Used a pin gauge for guide pin.
Not the prettiest but not bad limited to a drill press and hand tools.
Looks great. Nice job!
"Investment" is the new "Throw money at it!"
Detectives, and Cobras, and Agents!
Oh my!
I notice the guide pin is held by a set screw........can it be changed out for different sized case necks?
I know, it's been over 2 years.
How has it worked so far?
Has there been a version 2 yet?
This is the only post I have found on the net where someone made one.
I have a bunch of HSS tool bit blanks and some 1" X 2-1/2" aluminum bar stock so will be giving it a try.
I figure to polish .001 off the O.D. of some 29/64 drill rod for the .451 pilot and using the drill itself to make the pilot bushing hole.
A square notch in the side should work for the tool steel to fit into.
Last edited by archangel2003; 11-29-2017 at 09:24 PM.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |