So I finally started casting some slugs. I selected the Lee 7/8oz because it seems to be tge most accurate out of smooth bore barrels and both my shotguns are smooth bore.
First Lee mold I bought only lasted me 2 casting sessions (about 200 slugs each session) before failure. The mold is dinged up and tgat's most likely my fault because I didn't lubricate tge mold sufficiently.
The second Lee mold I bought after the 2nd session would start loosening up and now both the sprue plate screw and the center pin screw are stripped.
Lee needs to use stainless steel instead of easily stripped soft aluminum for their molds.
Now I am considering getting the Lyman parachute looking pellet slug. But I'd need to get rifled barrels for my shotguns to shoot that slug.
Very disappointed in Lee.
Anybody else has found a way to make that Lee slug mold work for them?