I have a 22 cal mold that drops at .225.
I know it is generally accepted to have your mold cast .001 over the size you want, to prevent lube leakage.
Question#1 Can I run this thru a .225 die so that I am just lubeing it? or will this result in a mess due to lube leaking?
Question#2 What is the most you can size down a boolit without issues. Looking at 7mm thor by noe. Drops at .288 with acww. Could this be taken down to .285 in one pass?
So far, I have not sized anything but pistol boolits out of acww going down .001 with no issues.
I have not ordered any sizeing dies yet for the 22 or the 7mm until I can get some advice. Thanks in advance for your help.