Hello all.
I am a long time lurker and first time poster on these forums.
I have been reloading for 3 years and casting for roughly 2 years. I recently got into the swagging .224 out of .22lr brass and I have a full set of dies for such. Normally i cast for my 45 ACP and my .223 Rem however I have taken on a new toy and I need some help from more experienced people.
I recently decided to bite the bullet so to say and I bought a Mosin Nagant. It was a purchase that was a long time coming however, with my recent promotion I have not had the time to support my hobby. I was talking with a coworker of mine who says you guys are the go to people for info and help so here I am.
I am looking for your suggestions on what mold to get for my Mosin. I slugged the barrel at .312 and i found several different molds that I could use.
Also any of your favorite loads that you would not mind passing along that I could try would be greatly appreciated.
I have several hundred boxer primed PRVI Partizian brass casings that iv picked up at the range over the years in anticipation of this point and iv finally gotten here. I have all the needed hardware to reload these bad boys however I lack the knowledge on the round.
Please help if you can.
Thanks!