I picked up another Star this week from GB.
Whoever used it last rode it hard and put it away wet. Musta been left out under the rear bumber of his pickem up truck.
The pics showed it as being rusty but nothing that appeared to be all that bad so I pulled the trigger on it.
While I was cleaning the rust off I found a crack in the upper casting. Haven't used it yet but I don't think the casting moves during the sizing operation. If it does, I'm sure there are ways to "fix" it so it doesn't move.
It had a .452 die in it (on ebay now) which will be replaced with a .356 die.
Interesting side note - the marking on the die was extremely faint from some type of electric pencil. I couldn't tell if it was an impact pencil or electrical discharge marker. At least I could still make out the marking.
Pics attached to keep this thread from sucking....
Here it is after a few minutes cleaning
Here's the crack