I am brand spanky new to this realm of loading so my ?'s might sound simple. I "watched" my dad cast tons of bullets, both pistol and rifle. I understand the concept and the safety issues. I understand the different tools. I am finding out by way of reading y'alls posts that there are LOTS of variables involved. What I have at the moment as far as tools and supplies are this, Lyman production pot, 2-5 gallon buckets of wheel weights, a new in the box Lee rifle mold for 7mm, Lee lube and sizer. So I guess my question is what else do I need besides the safety equipment, have that also. I was hearing that Lyman Alox is good for putting on the bullet molds v ribs and pins along with the sprue plate pin. Is it also good to flux. Please any and all suggestions are welcome. My father passed away this past year and I am lost without his knowledge. Thank you