I'm about to start casting. I started a while back, but was have horrible results from using a Lee ladle. I finally bought an aftermarket barrel for my Glock and a Lyman ladle. I am using the small Lee furnace. I have the Lee 230 grain 300 BO mold, a 312 155 grain mold, and a 356 124TC 9mm mold. Based on what I have been reading, I want to skip lubing altogether and go straight into powder-coating. I have been looking at the HF setup. My questions are: will I still have to flare the cases once powder-coated, or can I simply load them (300 BO at least) like FMJ? Since the 155 is a GC design; will I have to buy a gas check maker as well, or can I simply coat and shoot them as is? I'm not looking for match grade accuracy, but 1-2 moa would be fine by me. Any (constructive) guidance offered will be greatly appreciated.