I need some advise.
My finished reloads in 40 S&W are not chambering in my Glock barrel, Lone Wolf barrel and my case gauge.
Bullet is dropping into Glock barrel but stopping with the thickness of the rim extending beyond feed ramp.
Bullet will not chamber into the Lone Wolf barrel at all.
The boolits are coming out of my lube sizer a perfect 401.
Would going to a smaller sizer die of .400 be of much help?
I was planning on using the Lone Wolf barrel exclusively for my cast reloads and right now I'm at an impasse.
I'm thinking i might have to send the barrel back to Lone Wolf to have the chamber opened up a bit.
All of my brass has been run thru the Redding GRx die so there is no bulge.
Case flare is at bare minimum to seat boolit with shaving lead and I am using a Lee taper crimp die.
Any help would be appreciated.
Nick
West Virginia