I have had this rascal for several years, it never really did impress me in the accuracy department. I am going to try cast and figure to make this my winter pistol project. So if all of you would be so kind as to enlighten me as to what I need to check to properly fit a boolit to a revolver.
I only have one 44 mold for the time being,a 245PB. I had shot some 300's in FLGC's in the past with better luck, am leaning that way if I am advised to do so. This will be used from 50M-200M. I could live with a 6" group at 200, but I wouldn't like it, 3-4" would be more to my liking.
If this one will not shoot it will be sent packing and an FA will be found to replace it. So please help me save some $$$$, lol.
I might also add I think this would be a good one to keep on a "sticky" as this subject can have a LOT of variations from some of the reading I have done. I have talked to a lot of guys that have had problems with cast in revolvers, this would give a starting point for them at least.
Thanks in advance.
Jeff