Problems... So I lubed these last night, and let them sit until around 1800 after I got off work. Was conducting my "test seating" to ensure bullet seat depth was good for OAL/chambering etc... I put every one of these boolits through my .452 sizing die, and resized all the 45acp cases, and chamfered the case opening which is measuring .4545-.4550. The boolits are being shaved, very slightly on the mouth of the case and leaving some lead on the very upper edge of the case neck. The boolits are 100% COWW water dropped at 650-675deg. What do I do?