Here is what the Powered end of the Weslo Tread Mill looked like
with the Plastic Cover off.....Animal Hair coating everything !
I took the entire thing completely apart on my driveway pad.
Lot of nice tubing, bolts, a big black fiber fiber board that the tread slid
over, a tough tread strip, plastic feet and rollers.
Here are the goodies I wanted....
This PC Board goes for $133 on the Internet -
http://www.wesloparts.com/diagram_pa...agram_id=16555
The Input to the Controller (the "Console") is here and it looks like a bitch
to try to simplify.....then again - it might be a nice Lathe Control Input Panel !
The Console goes for $114 - http://www.wesloparts.com/diagram/16555
Here is the Repairman's Guide Spec Sheet (Front & Back) which was in a plastic bag taped
inside the Console.....lot of nice information for anyone interested....
Notice the Specs for the Motor !
Here is the Label on the D/C Motor (I Do not see the ubiquitous "Made In China")
This Motor goes for $157 - http://www.wesloparts.com/diagram/16555
Knew it had to be SOMEWHERE ! On the side of the Controller PC Assembly...
Here is the Motion Sensor Magnet for the Tachometer - on the Belt end of
the Ball Bearing Tread Roller where the sensor is mounted.
Not too shabby for $37.50 plus WA State Sales Tax...... !
I know it works 'cause I made them plug it in at Goodwill and made it speed up & slow down.
Now - can someone tell me how to get that Fly Wheel off the Motor Shaft w/o
boogering up the motor ?
I will need to put some sort of "Screen" around the Commutator to keep Lathe Swarf
from making my life miserable....
DoctorBill