Any ideas where to look for data for the Magtec 12 ga brass hulls? Thanks!!
Any ideas where to look for data for the Magtec 12 ga brass hulls? Thanks!!
Black powder
I just started loading pyrodex RS
http://www.tbullock.com/bpsg.htm
http://www.ballisticproducts.com/Rel...info/00MBRASS/
I bought this book. Ballistic products will show you which wads to use.
Has helped some
Darrell
Last edited by Wickyd; 05-11-2013 at 07:26 AM.
120grains black is "max" (for me at least!) and then shot equivalent ie. same volume of shot as powder.
Remember that the actual caliber of the thinwalled brass is 11 gauge not 12 so standard wads are out.
You end up using 10ga wads. I use a cotton dobber dipped in melted BP lube to hold my top card on. I have used only brass shells for my Bp shotguns for the past five years, very easy to use and good results.
Here is what I've gotten and use to load them.
Magtech 12 gauge brass shotgun shells are for 2.5" long chambers and accepts large pistol primers. Uses Buffalo Arms 10 gauge overshot wads #CFOS and 11 gauge Nitro (#CFNITRO) and 11 gauge fiber wads (#CFFIBER). You can substitute RMC11FIBER 1/2" Ox-Yoke Prelubed 11 Gauge Shotgun Fiber Wads Bag of 500.
Joe
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |