If this topic isn't in the correct place, let me know and I'll repost it in the right spot!
What is your favorite reduced load?
The ones you would put together for rifle or revolver?
Bill
If this topic isn't in the correct place, let me know and I'll repost it in the right spot!
What is your favorite reduced load?
The ones you would put together for rifle or revolver?
Bill
6.5 grains of Red Dot under a 250 grain keith boolit, in a 45LC.
I shoot a thousand or so per year of this load.
I'll be a nice to you as you'll let me be, or as mean as you make me be.
Polite society started dying the day it was no longer necessary for rude men to physically defend themselves from the consquences of their actions or words.
..............45-70, 12.0 Unique and either the Lyman 292 FNPB or the RCBS 300gr FNGC.
30-06 is 8.0 SR7625 and the Lee C309-113F
357 is 3.0 W231 and most any 140 to 158 WC or SWC.
...............Buckshot
Father Grand Caster watches over you my brother. Go now and pour yourself a hot one. May the Sacred Silver Stream be with you always
Proud former Shooters.Com Cast Bullet alumnus and plank owner.
"The Republic can survive a Barack Obama, who is, after all, merely a fool. It is less likely to survive a multitude of fools such as those who made him their president."
Shrink the State End the Fed Balance the budget Make a profit Leave an inheritance
.45-70 or .458 Win Mag -- .457 roundball & 9 gr Unique It's a real zipper, resonably accurate (enough for rabbits and coons), and quiet.
11 gr of Red Dot in basically any military cartridge of the 30 cal class with bullets up to 200 gr.
19.5 grs. of 4759 with 180-205gr. cast gc bullet in the .308 Win.
My Standard Loads, where typical means start one grain lower than shown:
32WS is 30-33 of any of the H335/WC844 variants with the one and only RCBS 170 grainer.
35Rem is 38-40 of any of the H335/WC844 variants with any of the 180 grainer boolits.
308W is 23.0 VeeVee-N120 and the Lee C309-113F.
22-250 is 15.0 VeeVee-N110, or 19.0 VeeVee-N120 and the Lyman 225646.
222 is 9.0 BlueDot, or VeeVee-N105 and the Lyman 225646.
357Mag is 13.0 WC820 or 13.0 AA-9, any boolit/bullet at or less than 165 grains.
44Mag is 19.5 WC820 typical or 18.5 AA-9 for any boolit/bullet at or less than 250 grains.
41Mag is 17.5 WC820 typical for any of the 220-230 Keith types.
45Colt is a case full of RL7 or WC680 with any boolit heavier than 300 grains with zero compression, boolit just touching powder. This is NOT a cowboy load.
... felix
felix
11.5 grs. of 820 with 115 gr. RCBS cast gc boolit in the M1 Carbine. Ron
30-06 - 20-22/4227 and just about any GC'd 165-200 grainer
35 Whelan - 38-40/4895 or 40-42/4064 and 358009 (not really a reduced load)
6.5x55 - 17.0/4227 and Ly 150 grainer (don't recall the #)
32 Win Spl - what Felix said
308 Win - 4895 and 311041 and push it as hard as accuracy allows
30-30 - 16.0/4227 and 311041 (this is a very mild shooting and accurate load)
.357 Mag - 10.0/HS7 and 358156 (nice medium load)
35 Rem - 4895 and the RSBS 35-200-FN (you pick the charge/fps)
44 Mag or 44 Spl - any of the Grn Dot cowboy loads (I prefer Lee 200 RF for the light loads)
5gr BP or Sub under Farina and a 180gr pure lead boolit in .38 or .357... though I may try 1gr Titegroup next...
A Democrat that owns Guns is like a Vegan that owns Cats...
C2N14... because life is not energetic enough.
Gott und Gewehr mit uns!...
Death is only The End if you assume the Story is about You.
1.618034 Fnord
מנא, מנא, תקל, ופרסין - Daniel 5:25-28 - Got 7.62?
357 Magnum 4 grains TiteGroup and any 158-160 grain cast bullet (cowboy load)
357 Magnum 15 grains H110 and 170 Sierra JHC, 13-15 grains H110 and any 180 -200 grain cast bullet [Federal 205 primers] (full power loads)
375 Win./38-55 23-25 grains H4198 255 grain cast bullet.
44 Magnum 6.4 grains TiteGroup and any 240 grain cast bullet (cowboy load)
45-70 25 grains H4198 & RBS 45-325-FN-U Plain Base
Group Buy Honcho for 311440Mod, 312190-FNGC, 379230-GC, 380200-GC, 381268-PB, 360180-GC, 360180-PB, 413640-PB, 434330-GC, 434640-PB, 434640-GC, 454640-PB, 462420-PB, 462420-GC, 462420-PB Re-Run, 462420-GC Re-Run, 462640-PB, and 462640-GC Group Buys.
Lever Guns are my Passion!
SASS Life 37141
IHMSA 33587
Most of my rifle CB loads could be called "reduced," being in the 1400-1800 fps muzzle velocitiy range. To avoid redundancy, I'll list only one greatly reduced load. Rifle and revolver .44 Magnum load: 7.0 gr. Green Dot/RCBS 245 PB SWC. This load is very accurate in a S&W 8 3/8" M629, mv 950. It also shoots about as good as any load in a Marlin Cowboy 24", mv 1200.
Eagles have talons, buzzards don't. The Second Amendment empowers us to be eagles. curmudgeon
30 - 06 Springfield
11.5 grs. Unique
Cast bullet 160 - 200 grs. in weight.
Always an accurate load in all 06's I've shot it in.
Ben
This thread needs a sticky...
Shoot Safe,
Mike
Retired Telephone Man
NRA Endowment Member
Marion Road Gun Club
( www.marionroad.com )
6 grains Red Dot under 150 or 170 grain gas checked in the 30-30 or 32 Special. Lobs them in slow and quiet.
10.0 grs Unique in .308 WCF under 100 grain Speer Plinker or 110 gr cast bullet, guesstimate it being about 1550 fps...
My favorite reduced load for the 308 is 16grains of 2400 powder under the RCBS 30-180 bullet Bob B
30-30: 6 gr of 4756 under a 170gr cast bullet, with a GC it averages 980fps, plain base averages 1057 fps (not sure why that is..). Accuracy is very good out to 50 yards but requires moving the rear sight up three notches to be zero'd, minimal recoil and report. It shoots very clean too.
45-70: 11gr of Red Dot under a 405gr cast bullet. averages just over 1000 fps in all of my 45-70s regardless of barrel length. Easy shooting and accurate out to 100 yards.
Trail Boss is your perfect reduced load powder. Designed for bulkiness to fill the case and still maintain the low pressures that are favored by Cowboy Action shooters. My 44 caliber loads (44 special and 44-40) really like 5.5 grains under a 200 grain projectile.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |