I got a 6 banger off of another board member, a leftover from a fat 8mm group buy. Nice mold. However...............
I went to operate the cam to open the mold. I found it to be too hard to cam over by hand, using straight wheelweights! This despite using bullplate (which initially I found to be very nice...) So I tapped it with a stick, ala normal 2 and 1 cavity molds.... and broke the metal handle on the sprue cutter! Sheared off right at the point the metal enters the wooden handle.
I ordered a replacement from Lee, but being as it appears to be pig metal, anyone else ever experience this?