I think its a wildcat anyhow...
I am turning a bunch of 30-06 into .308 And I ran into two problems.
I have the dies set up to headspace the .308 to 1.627. When I size the 30-06 cases, the headspace comes in at 1.634 or thereabouts. Is this normal? Do I just re adjust my dies to compensate?
Second issue. The necks get thicker, and I have a Forster neck tool on the way to deal with it, but when trimming to length, the pilot is binding up in the cases, tighter the further down I go. This makes it so I cant trim them down to length.
What do I do?