Picked up a Rossi 92 a while back with a tang site and the rear site removed and no where to be found. Really dont like the tang site and want to put a rear site back on it. So out come the calipers and I find the DT measures .398 on the right hand side and .375 on the left.
I cant recall ever measuring a dt cut and getting two diff. measurments but I dont do it often so maybe I did and just disremember a bit
I have read that the newer Rossi's have a diferent DT cut size than older ones but I only have the one so no comparison. If it matters, mine has a 24 inch barrel that is a half octagon with a serial # lower than 60000
First question, is it common for a DTD cut to have different measurments as described,?
Second question, where might I find a rear site to fit?