In
THIS Post I offered a schematic to add LED warning lights to you PID set up.
Well, I now have PC boards to simplify the wiring. The boards are 2.1" long and .8" wide with 2 mounting holes. You simply add the components and solder them in.
Complete with instructions for correct set up.
I need $10 plus shipping for these.
I know, they're a little bit expensive, but that is the problem with a small run.
These are offered at my cost.
I only have 10 of them, I kept 2 for myself. 12 was the minimum order.
For a little extra, I'll even add the components, all you do is solder in 4 wires and mount it in your project.
I also have all components needed for this project if you need them.
Red, Green, and Blue LEDs as well as the diodes and resister.
PM for purchase.