Can anyone recommend a mold for 7.62x39 please?
Thanks.
Can anyone recommend a mold for 7.62x39 please?
Thanks.
The best place to start selecting a mold is slugging your bore to get an accurate groove to groove diameter. plus.002" from there is a typical diameter.
lighter boolits are selected for reasons like varmint hunting, plinking loads and cost saving. medium and heavy boolits are selected for reasons like kill power for larger game, long range accuracy and metal target knock over.
most 7.62x39mm rifles slug at .310- 312" some American X39s will slug at .307-.308". there can be even wider variations . Start right and get an accurate measurement from slugging your bore and avoid a lot of frustration with inaccuracy and leading caused by undersized boolits.
Here are some common selections:
Lyman #311459, Gas Checked 115 gr pointed
Lyman # 311410, Plain Based 130 gr RN
Lee # C312-155-2R, 155 gr Gas Checked 2 Radius Ogive point
Lee# CTL312-160-2R, 160 gr Gas checked Tumble lubed 2R point
There are also some 313" and 314" diameter bullets designed for other cartridges that will size down to fit the X39 well.
Gary
Last edited by onondaga; 07-25-2011 at 06:21 PM.
I use this one in my .303 British but it should work just fine for a 7.62 x 39. In fact I think it was designed for 7.62 x 39.
There is a group buy on right now:
http://castboolits.gunloads.com/showthread.php?t=104096
Longbow
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |