Hi, all!
First post here. This looks like an interesting site. I cast bullets for my .45 Colt, .45 ACP, and .38/.357. The .45 Colt gets hardcast, gas-checked 300 grain bullets for deer and wild hog hunting, at about 1300 FPS. The ACP and .357's don't run quite that speed. I've been using a homemade lube I concocted from toilet seal rings and general-purpose chassis grease which is just hard enough I need to warm up my Lyman Lubrisizer a little to make it flow reliably. The formula you're discussing here seems awfully complex by comparison. Is there any particular reason for so many ingredients and all the steps to the procedure? Educate me!
Jerry