I recently bought the mould and have cast a few hundred that are very nice looking. My problem is what load and AOL should I use. I am using Titegroup. I also have the Lee T356-124-2R. With this mould, I am using 3.8 grains with a AOL of 1.125. With the TC, if I use the same AOL, the top 2 lube rings are exposed. Will this cause a problem as it wont be seated at the same depth as the 2R? I have dropped a TC with the 1.125 AOL in the barrel and it slides in and out with ease. I will be shooting them out of a S & W SW9VE and a Ruger SR9c. The 2R's shoot very well out of the Sigma, haven't used them in the SR9c yet as it is my wife's and she just got it so we shot around 75 rounds with the expensive store bought stuff to break it in. Thanks for any input.