I got a deal on quite a few lead balls, and bullets, that I guess have oxidized. Are they OK to shoot and hunt with like they are, or should they be cleaned up? And if so, HOW?
I got a deal on quite a few lead balls, and bullets, that I guess have oxidized. Are they OK to shoot and hunt with like they are, or should they be cleaned up? And if so, HOW?
They are going to be noisy in the washing machine.
Just kidding!
No .... just shoot them .... if you had exposed lube and dirt there I'd be wary of a grinding compound effect from it.
But just oxide on the outside of the lead will not hurt anything.
Shoot away!
Three 44s
Most of them are not lubed, But there are a 100, big 45cal bullets that are lubed, and have some grime on them. Can anything be done with them?
If I was concerned about them, I would melt them down and remold them.
Sean
One way I've used gritty boolits is to place the boolits on a paper towel in a metal pan and melt the lube off in a low oven ( 160 - 175 degrees, below the flash point of paper) Lube melted and draind down and absorbed by paper towel.
BTW, before the flames start I've done this many times and the paper towels don't burst into flame and none are even singed...
My Anchor is holding fast!
Or boil them in plain water in an old pan and then tumble lube them.
boil the lube off them.
lead oxide is hard stuff [airc it's about 50 or more on the bhn scale]
you can run the cleaned boolits through your tumbler to shine em up then re-lube.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |