I recently picked up an RCBS Lubsizer -1. My problem is that none of my H&I dies fit deep enough into the body to allow the locking cap to screw into the body about 3 threads or the H&I die sticks out above the body about 1/4"
>>>>>>>>>>> ______
......................... _____l l______
Where in my Lyman 450 they are almost flush and the locking cap screws all the way down.
I cleaned this L/S and the bottom of the body where the H&I die fits is flat. Is that part supposed to have a bevel to mate up with the bevel on the bottom of all H&I dies ?
Any Help will be greatly appricated, hopefully this unit will not have to go back to RCBS