Here's my situation. I have just been given an RCBS 8mm mold for a 170 grain bullet. The only powders I have are 4759, Varget, and 3031. What are the minimum and maximum charges with each of these powders that I could use with this bullet?
Here's my situation. I have just been given an RCBS 8mm mold for a 170 grain bullet. The only powders I have are 4759, Varget, and 3031. What are the minimum and maximum charges with each of these powders that I could use with this bullet?
Straight from the RCBS Cast Bullet Manual #1.
Mauser 98
24" bbl.
1-9 1/2" twist
Federal cases
CCI 200 primer
21.0 SR4759 1703 fps
23.0 SR4759 1850 fps
That's the only powder listed that you have.
This is with the group buy mold, but is close enough for planning purposes.
18-5 22.5 grains of 4759 8x57 in more than one version of 98 (one very shiny bored 98 shoots patterns with all loads). 175 grain RNFP GC GB mold and 21.5 grains of 4759 = 1685 fps measured.
Groups got smaller and smaller from 18.5 - 21.5 grains, 22.5 looked like buckshot pattern . . . . VERY loose pattern at that.
YMMV.
Louis
Last edited by TCLouis; 12-13-2009 at 10:35 PM.
Amendments
The Second there to protect the First!
What 8MM is it? Is it a 8x57mm or is it a 8mm/378 Weatherby or one of the other 100 or so 8mm cartriges. Same old story, people giving you load data for the cart. that they think you are asking about.
does not any one of the questioners have loading manuals or is that the new system guess and pray.some one is going to wear a bolt yet.
WILDCATT
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |