Preferred method for sizing powder coated boolits

[Land Owner]

For powder coat I like to size before and after applying PC. I use a different size die before and after.

That is how I roll, But still use my r c b sizer For both. I don't know if it Will deform The previous bullet nose if I were To push through. I may have to try that. Certainly.It would work for all flat nose bullets. Spitzer's maybe not so good

[K43]

Another NOE sizer in an old Spartan boat anchor C press user. I do have two Lee push-through sizers I used to use with the Rockchucker, but NOE has a vast assortment of sizes so I don't have to do any polishing/reaming to get the diameter I want. A hair over beats too small every day.

[justindad]

push through with a twist
dedicated single-stage press mounted upside down. just place the bullet, nose down in the die, and work the handle. you get used to the movement in no time

I also built a ramp out of a short section of PVC pipe so the bullets would slide down into the die. makes the operation much quicker but takes a bit of work to get the speed of the ram just right so they fall in the hole

That’s awesome.