Alloy for PPB?

[Lead pot]

LOL, I over lap and under lap and I cant see any change on the holes on the paper.


Here are some good bullets. I don't know what the twist your rifle has but this bullet is more for the slower twist and the base diameter will patch to groove and the shank to bore diameter.https://www.buffaloarms.com/371-310-...im371310e.html


This is the bullet I use in my .38-50 Hepburn that has a 12 twist with a .110" freebore. The longer groove diameter base fits the freebore. This is the bullet I used for the target I posted above.https://www.buffaloarms.com/371-360-...im371359e.html

The two diameter pp bullet is a good design. No need to size the necks to hold the bullet.

[Don McDowell]

Depends on the paper
My dual diameters with 8 lb don’t particularly need cases sized but if I run the 45-90 into a119 size due I like the neck tension better but I don’t know that they shoot as well as the 7 lb wrapped with sized and expanded with a 456 expander
Just takes a bit of tinkering around looking for the holy grail
I’m thinking after I get my eyes fixed I may have found thee load for my Shiloh 77

[Lead pot]

I hope your eyes turn out better than mine. Still having problems with mine.

[Don McDowell]

Still waiting to see what they're gonna do.