1. original walnut stock from a Rem 40X Rangemaster, heavy barreled repeater, originally a 308 Win. The barrel channel is approx 1.5" wide at the front action screw hole and 1.125" wide at the forend. Stock has several very light dents, around .015" deep and a few scratches, .5" rubber butt pad is still functional but shows obvious wear from being in a dry environment and should be replaced when the stock is re-finished to make it a truly nice looking stock. The front sling attachment is missing but the inletted, metal receptacle is still there. No action screws or bottom metal. $30.00 shipping via USPS, (lower 48), and $150.00 for the stock AK and HI let me know I will get a USPS estimate for you. USPS money order or if too much trouble any other money order and if that's too much trouble then a check. * * REFINISHING FOR SALE AT A FUTURE DATE * *
2. RCBS 180 grain gas checked silhouette mold, SWC, I've made probably 2-3k bullets using this mold, vent lines still look nice and sharp, inside of cavities no rust or corrosion, outside of blocks had some very light corrosion/discoloration which I removed with some copper scrubbing pad,(chor-boy), and Kroil, never used any sort of mold release on this mold. $50.00 and $10.00 shipping via USPS, (lower 48), AK and HI let me know I will get a USPS estimate for you, (should be same if priority Mail). USPS money order or if too much trouble any other money order and if that's too much trouble then a check. * * * SOLD * * *
3. Ruger 10-22 blued, Target/Varmint barrel, threaded at muzzle, with protector, .920" at breech end, .745" at muzzle, 20" length, no rust or corrosion anywhere, inside or out, when I removed this barrel from the receiver in order to replace it with an aftermarket barrel, I noticed that the front action screw had been lightly contacting the bottom of the barrel. The after market barrel shoots about the same, maybe a little better, (hovers around .4-.6" at 50 yards, (inexpensive SV ammo). When this barrel was in the gun I always got 1 flyer per 5 round group, then I swapped out the barrel. Still got that flyer, then I swapped out the bolt with a KIDD bolt. No more flyers. $30.00 for shipping USPS, lower 48, (AK and HI let me know I will get a USPS estimate for you), $50.00 for the barrel, USPS money order or if too much trouble any other money order and if that's too much trouble then a check. * * * SOLD * * *