Looking for 7.62 Nagant

[sigep1764]

Hi folks!
I am looking for 7.62 Nagant/7.62x38R cases. If someone has some they would be willing to part with, please let me know!
Thanks all!

[btreanor]

I recently bought some from these guys: https://store.mojoprecision.com/prod...2&_ss=e&_v=1.0

There were a couple of Berdan cases in the mix but otherwise a pretty good deal.

[poppy42]

I don’t wanna get your hopes up but I had about 30 pieces of it for the longest time. if I can remember where I put it and if I still have it I’ll send you a PM you can have it. I’ll gladly send it to you. I saved it because I knew I’d find somebody that needed it someday.

[2TM101]

I am looking for 7.62 Nagant/7.62x38R cases. If someone has some they would be willing to part with, please let me know!
Thanks all!

Are these the one for the revolver?

[HARRYMPOPE]

I have 50 new PPU I just ran across.
I'll see if I can remember where I put them!

see below, in stock and a great company

[HARRYMPOPE]

https://www.buffaloarms.com/7-62-rus...c-ppu762n.html

[Kestrel4k]

Deleting my post as well; was written very poorly, so could easily be taken the wrong way.
Thank you & best regards,

[HARRYMPOPE]

Please delete my comment I misunderstoo

[sigep1764]

Yup, this is the brass for the Russian revolver. However, I'll be using it to shoot in my Winchester 1905 in 32WSL.
Thank you for the link to Buffalo Arms. I checked 2 weeks ago and they were out. I'll use them if no one here has any. Not that I object to Buffalo, I would like my money to go to someone on the forum first.

[poppy42]

I’m still looking!

[dogrunner]

Sold all mine with revolver so sorry. Word of caution tho, beware of Bertram brass........hi dollar and all I had started splitting badly as NIB.........., suggest annealing on acquisition.

[ascast]

How many are you looking to have? I believe 32-20 wcf can be used. you might check the archives for load data etc.

[Rockindaddy]

I once had a WWII Russian bring back by a GI. I cast 32-20 wcf boolits out of a factory mould. I sized and lubed em. Used 32-20 brass and my cast boolits. They shot great. Think I even used a set of Lyman 310 dies in an old press.

[sigep1764]

32-20 is a little too short in my die set. It will not crimp. Thank you for the suggestions!

[Battis]

I just bought 100 pcs of 32-20 for my WSL .32. I use a WSL 32 die and a 32-20 die on the 32-20 brass.

[sigep1764]

Bump for the weekend!