Prices Reduced...
$10 Shipping for whatever you take, USPS Priority flat rate to USA addresses only.
Photos included below.
A. SOLD Lyman mold handle for small block, wood has partial crack on one side-but still is on tight and usable as is, was $20 Now $10
B. SOLDLyman mold handle for small block, was $25 now $15
C. SOLD Lyman mold handle for Large block, wood has partial crack on one side-but still is on tight, also other handle(the long side) has been epoxied on, was $20 now $10.
>I know someone is gonna ask, typically Lyman makes one cavity molds on small blocks, and typically they make two cavity molds on Large blocks. But not always...Know you blocks before you buy these.
D. SOLD RCBS Handle, $25
E. SOLD RCBS Handle, $25
F. RCBS single cavity mold, 45-405-FN, Damage on top of cavity as shown in photo, it still casts real good, but leaves a fin on the base, which is easy to remove, then GC goes on easy, I tried to show boolits with fin in photo. Mold drops .460" and 414gr with COWW alloy. $60
G. SOLD Ideal single cavity mold, 311334 pointy, 195gr .3115" $35
H. Ideal single cavity mold, 358156 SWC, 155gr .359" $50
I. TC single cavity aluminum mold, 50 cal Maxi-Ball Conical, $45
J. Lee C309-160-R two cavity mold, But this one drops at only 145gr and drive bands .312 and Nose is .300 and it casts like a dream, $35
Attachment 322433
Attachment 322435
Attachment 322436
Attachment 322437
Attachment 322438
Attachment 322439
Attachment 322440
Attachment 322441
Attachment 322442
Attachment 322443
|
   
   
|
|
