If you load shorter cartridges you may find that the die manufacturer still uses full length die stems. These stick up high enough to be the cause of an accident. If you reach over behind your press you can possibly scratch your arm. Even worse, if you bend offer you could poke yourself in the face. I ordered some thread protectors from Amazon & put them on the stems that stick way up. Cheap safety tip - just FYI...
Hard times create strong men, strong men create good times, good times create weak men, and weak men create hard times.
The long stems are a pain. I've been known to cut them shorter, clean up the cut end making it nice and smooth. Then cutting a new screwdriver slot. Also saves the toolheads with dies in them from getting tangled together while sitting in the drawer.
Barring this the thread protectors are a good idea. Having the stems the normal length is also an idea as they can be used as a spare.
45_Colt
That is a very good idea. Every little bump seems to make me bruise and/or bleed these days. I have some of those in my hurricane shutter kit as I use them to cover the screws that don't get removed when the shutters come off. Gotta dig them out!
...even worse, the stems have some attraction for scratching not me only, but my guns when out the safe and handled around here...
thank you, sir !
Food is overrated. A nice rifle is way more important.
Rob
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote