Arsenal Mold Casting way small

[flatnose]

I’ve had problems with 2 molds from MP, one where the alignment pins wouldn’t stay put when the mold was hot and another that wouldn’t drop the boolits because the cavities weren’t centered perfectly(or close enough to centered). In both instances I communicated and sent pics to document the problems, Mihec sent me new blocks both times, on his dime. He even sent me a sprue plate one one of mine had a big warp in it now I think of it. MP molds takes care of their problems in my experience.

You are fortunate then. Many here including myself were ignored. gas check shank too big, wrong top punch. But main complaint is he does not care. The group buy got the same treatment. I wont go back to him and honestly there is not much reason as long as Accurate molds are available. Accurate is top notch and stand behind it.

[pull the trigger]

I shoot 356 out of a half dozen or more 9mm and 380 handguns and carbines. If they are pc'd, i dont get any lead in any of them, and they are plenty accurate for me. Please, please, please, dont anyone ever throw away any mold, just post it in the swap section with what ever the info you have is, give the rest of us a chance to buy it. The one you are discussing would be fine for alot of people, im sure.

[justindad]

Thanks everyone for sharing. I was eyeballing their .40 cal round nose mold, but I don’t want to pay good money for a bad mold.

[WJP]

Glad to know their quality and customer service. Don't think I'll be ordering anything from them now.