9.3x74R Brass cases

[RED333]

I am wanting to make some .410 shot shells. If you have a few, say 50 or so and are not using them I would like to buy them.
Thanks
RED333

[Huvius]

I have some Magtech 410 brass I would sell but the 9.3 will serve as well with a little work.

Krieghoff is a good source for once fired brass in some chambering they use for regulation.
Haven’t bought from them before so on’t know about shipping or if they ship from the US.

https://www.krieghoff.com/product/on...ral-9-3-x-74r/

[Fitz]

Graff & Sons had it in stock not long ago.

[RED333]

Thanks much, Huvius and Fitz.

[poorman]

https://www.buffaloarms.com/prvi-par...-ppu9374r.html

[Green Frog]

Red333,

I don’t know where you are in this project now, but I would steer you toward the Magtech 410 brass as suggested by Huvius. It will be cheaper and doesn’t require all the work of reforming. I have some of their 12 and 20 ga brass and it’s good to go as is. I’ve worked with Norma 9.3x74R for recreating old BP cartridges and it’s good stuff, but for 410 it will just be a lot of extra work.

Just as a FYI, there was some aluminum cased stuff that used to show up at gun shows a while back. IIRC, the story was that it was from a military contract for survival guns for air crews. I don’t think it would hold up as well as brass for multiple reloads though. If you just want something for one time use, it might be worth a look.

Froggie

[RED333]

I have found some 410 brass online. Thanks gentlemen.