.365 Sizing Die

[Divil]

I now have a 9x18 Makarov and dies. Brass is coming later this summer or fall. Does anyone make a .365 inch sizing die?

[fc60]

Greetings,

Lee markets a 0.365" die.

https://www.leeprecision.com/bullet-szr-punch-365

It is the new design and I believe you need a holder for it.

Cheers,

Dave

[Divil]

Thanks. The holder I have. I could go the tumble lube route.

However, doesn’t anyone make a .365 sizer to fit a Lyman Lube Sizer?

[flatnose]

Thanks. The holder I have. I could go the tumble lube route.

However, doesn’t anyone make a .365 sizer to fit a Lyman Lube Sizer?

I have purchased custom sizing dies from Buffalo Arms. They can probably make it.

[Divil]

A check of their website shows this item to be in stock. Thanks!

[vikingsword7]

I just recently started casting for my Makarov and the mold kicks out a .365,366 nugget which I planned on powder coating. I Had a Lyman .359 which I reamed and polished out to .363 which I used to size them down, then I powder coated them, they then measured .365+. I then ordered a push thru sizer at .365 and they came out perfect as my bore slugged out at .363.5 .

[leadhead]

I have a Lyman .366 diameter die that I don't remember where I got it, but Lyman made them
a long time ago. Don't know if they still make that size or not. It's perfect for the 9x18 Mak.

[kywoodwrkr]

C.I.P. shows many 9.3 cartridges in both rimmed and rimless rifle category. .366" = 9.295238095238095mm .