Finally got the ball turner to where I could test it out today. ground up a 3/16 square cobalt tool bit and it did good adjusted the radius and relief angles and its very good.
has 2 oil lite bearings with an oil cup on each to lube them 2 oil lite thrust bearings to set end play and tension. Small space between bearings for an oil supply.I need to cut a 3/8" hex in the shank for the handle yet, and make 2 stops to set in the groove so it cant over run.
This was the second time after the small changes
I found that turning a ball with the mill is easy. https://johntaylormachine.com/wp-con..._Machining.jpg
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote